Diecast Aircraft Information

MetalWings Diecast Aircraft Reference by Dauntless Aviation

The Spitfire Mk.1 first became operational in July 1938 at Duxford, Cambridge. At the beginning
of WWII 9 RAF squadrons were equipped with the Mk.1’s with two others converting to the new
aircraft. By June 1940 the Mk.1 was being replaced by the faster long-range Mk.II but not before
the Mk.I had bore the brunt of the Battle of Britain. The Mk.I also flew protective cover over the
evacuation of Dunkirk. The Mk.1A had 8 machine guns instead of 4, a bulged canopy, a 3-blade
propeller, self-sealing fuel tanks, armored windscreen and armor plating in front of and behind
the pilot.

K9795 was the ninth production Spitfire Mk.I and assigned to No. 19 Squadron commanded by
Sqn. Ldr. Iliffe Cozens located at Duxford. 19 Squadron received the first Mk.I’s because
Duxford was being expanded and could handle the high-performance aircraft also VIP from
London were close enough to access the new fighter. The number 19 markings using white
signified the aircraft belonged to “B” Flight, yellow was used for “A” Flight. On October 14, 1940
K9795 crashed due to engine failure. The pilot was uninjured but the aircraft was a write-off and
SOC (Struck Off Charge).

Specifications for Supermarine Spitfire Mk.1A (late production)

Role – Interceptor Fighter

Mk.1A Produced – 1,536

Crew – one

Performance
Engine – 1 x Rolls-Royce Merlin III, liquid-cooled, V12
HP @ Altitudes –
1,030 hp @ 16,250 ft (4,953 m)
880 HP @ take-off
Speed
Maximum @ 20,000 ft (6,100 m) – 353 mph (568 kph)
Cruising – 210 mph (338 kph)
RoC (Rate of Climb)
Initial – 2,530 ft/min (771 m/min)
Time to 20,000 ft (6,096 m) – 9 minutes 25 seconds
Service Ceiling – 31,900 ft (9,723 m)
Normal Range – 395 miles (637 km)
Endurance – 1.78 hrs

Weights
Empty – 5,040 lb (2,286 kg)
Full – 6,150 lb (2,789 kg)

Dimensions
Length – 29 ft 11 ins. (9.12 m)
Height to tip of propeller – 11 ft 5 ins (3.48 m)
Wingspan – 36 ft 10 ins. (11.23 m)

Armament
8 x 0.303 in (7.7 mm) Browning machine guns, 300 rounds/gun

1/48 scale pre-finished.
Die-cast metal with a minimum of plastic.
Professionally painted.
All markings pad applied for superb results.
Canopy slides open.
Comes with a pilot that can be removed.
Comes with display stand.
Landing gear is fully retractable and can be displayed up or down.
Propeller is metal.
Extremely sought after by collectors.

Hobby Master 1/48 Air Power Series
HA7804
Spitfire MK.1 "K9795"
19 Sqn, RAF, Duxford 1938

MODEL COMES WITH A
RUDDER BALANCE THAT
YOU PLACE ON THE TAIL
WHEN YOU RECEIVE THE
MODEL.

This new site is being updated regularly and it will be much improved before too long. Please be patient, give it time, and check back regularly. Opportunities for community collaboration are in the works for a little further down the road.

This is not a retail site. You cannot buy models here.

Thanks to Dauntless Aviation for providing web hosting and other support for this site. Real or sim pilot? Check out their stuff!

This is not an official site of any manufacturer or retailer. Information provided here may be incomplete or in error. Use at your own risk.

This is not an "advice" site. Please do not contact us asking about these models. Please contact a manufacturer or retailer with your questions or comments.

Please update your links!

Update HomePage links from the HMC website to either www.MetalWings.com or, preferably, www.dauntless-soft.com/MetalWings.
Update your page links to this page from HMCwebsite/HA7804.html to http://www.dauntless-soft.com/MetalWings/HA7804.asp

This site will be modified over time. We are well aware of its many issues, including missing images and bad formatting.